home *** CD-ROM | disk | FTP | other *** search
-
- UNPROTECTING MIND PROBER
-
-
- The operation to remove the copy protection is very simple. An added
- benefit to removing the copy protection is the ability to put
- Mind Prober on your hard disk, without the need to have the original
- disk in Drive A: at startup time.
-
- Follow the steps below for removing the copy protection. Be sure to do
- this to a copy, and not to the original disk. Use the DOS COPY command
- to make a copy onto another floppy, or to move a copy to your hard disk.
- Then perform the DEBUG steps to the copy.
-
- 1) RENAME MP.EXE MP.1
-
- 2) DEBUG MP.1
-
- 3) S 0 F000 CD 13
-
- (Note: Two locations should be found, at xxxx:70DC and xxxx:70EC. If they
- are not at these two addresses then stop, you must have a different
- version than I. The values xxxx are unimportant.)
-
- 4) E 70DC 90 90 90 90
-
- 5) E 70EC 90 90 59 EB
-
- 6) W
-
- (Note: A 'Writing DC3A bytes' should be displayed. The above Edit commands
- tell the Mind Prober program to not bother looking for the bad
- sector located on the diskette.)
-
- 7) Q
-
- 8) RENAME MP.1 MP.EXE
-
- You are now all through with the δΦrnges, and should have a non-protected
- copy.
-
-
- J. R., otherwise known as "Hacker Jack" of Lake Jackson, TX